...
Remove power from the F200.
Press and hold the SCV button.
Apply power to the F200.
The lights will be on for about 5 seconds and then turn off.
When the run RUN light turns on about 20 seconds later, release the SVC button.
The lights will turn back on for approximately 10 seconds and then turn off.
Wait until the run RUN light turns on solid. The controller has been factory reset, which should take about 20 seconds.
Then to access the Gateway, double press the SVC for the light to be solid red. Once solid red, access to gateway at https://169.254.169.254 will become available.
Note: If you can connect locally to the gateway, you can click on the Maintenance and click the Reset to Factory button as an alternative method.
...