| Table of Contents |
|---|
| Info |
|---|
| Prerequisites: a special pod that is enabled and contains the template. You can find out how to do that here: BACnet Template |
Read/ Write Property
We have created this form to read property tags properties from the BACnet device or to write them it to the device (if they are writable). These The properties that are going to be affected by this Tool are the same properties ones mentioned in the bacnetProperties.trio file from the .pod
How to use Read/ Write Property
The user will go to DB Builder
in there open the Connectors menu. From the right side menu select a BACnet connector and click on the Tools icon, in there choose Read/Write Property
(for more info check this)
| Info |
|---|
| Prerequisites: a special pod that is enabled and contains the template(s). You can find out how to do that here. |
1. The user will have to select on the DB Builder application which is under the System Integrator section
2. Once inside, the user has to navigate towards the Connector Tree > BACnet
- Underneath the Discover section, it will display a list of connectors that have been added by the user
- The user will have to select on a connector
- If there are no connectors, the user will have to add them by using the Discover button
- For more information, it can be found in the following document: BACnet Connector
3. Once a connector has been selected, the user will have to use the Tool button 
which is located on the bottom right
4. The user will be prompted with a pop-up called Tools where the user will have to navigate to the following: BACnet > Read-Write Property
5. A new window will pop-up showing the selected BACnet connector in the Effected Devices list
6. The first option "BACnet Device Filter" allows the user to create a filter with the selected desired devices to which the form is applied. Also the user can customize the filter to his desires by This can be done by clicking "Filter" and , a new window will appear and click Execute when finished (also, he can check if the conditions are alright will be triggered to allow the user to configure the desired devices
- Once the filter is done the user will click Execute (The filter can be checked by clicking "Test" in the left bottom corner and will see the results in the middle)
Finally, at the bottom the user will chose 
7. In the Read or Write section, the user will choose the desired action of the form Read or Write and hit Apply
| Info |
|---|
Note that not all properties from the device are writable |
In the end after hitting Apply the user will be sent to Folio, where the jobStatusAll() querry was ran and shows 
8. After selecting Apply, the user can go into Folio and type in jobStatusAll() query
- This will display the result of the forms' action
