| Table of Contents |
|---|
Sub Block
The Sub Block allows the user to subtract a variable's value from another in order to use the result
...
The only properties that the sub block has are the two input fields: A and B, where the user must choose the variables (parameters)
...
How to use
The user must go to bLine Logic
...
In there he creates a program (or edits one) depending on his need (more information here ).
In the Blocks menu the user can find all the blocks that he can use
...
Search for the sub bock in the right menu that opens 
...
Then drags the block over a main block like SET or IF
...
From there, the user just chooses the variables (which he can see how to add them, in here)
Example
Create a program and add the following variables
Then set The screenshot represents a very basic setup on how to use and apply the and block.
We set up the value of deltaT as a subtraction .
After, use the new value of deltaT to set an alarm ON of OFF, by using the comparison signs (greater, equal, less than).
At the end there is an Alarm routine, you ca find more about it here
of cTRT and cTST, then if the value of the subtraction is greater or equal to 10 we turn the Alarm On, if not the Alarm is set to Off
...