The Debug Info form allows the user to view information about selected connectors in one single view

1. The user will have to navigate to the DB Builder tile which will be underneath the System Integrator Applications section

2. Once inside, the user has to navigate towards the Connector Tree > BACnet

Underneath the Discover section, it will display a list of connectors that have been added by the user
The user will have to select on a connector
If there are no connectors, the user will have to add them by using the Discover button
- For more information, it can be found in the following document: BACnet Connector

3. Once a connector has been selected, the user will have to use the Tool button which is located on the bottom right

4. The user will be prompted with a pop-up called Tools where the user will have to navigate to the following: Debug Info

3. After clicking it, a window will pop-up called Debug Info

The form will show different information depending on the type of connector the user selected (can be either Bacnet or Haystack)

Among the information displayed for both type of connectors, the user can see:

BACnet	Haystack
For BACnet connectors the user can see: device name vendor name model name protocol version status segmentation COVEnabled	For Haystack connectors the user can see the URI the product of the device the module

Browser not supported