We need to make Fin Stack run on port 37 for the Time Protocol, have the value return a 32 binary time in millis

FIN needs to run on port 37 for the Time Protocol, and have the value return a 32 binary time in milliseconds. Read the information below to review the process of setting up the server to be the main source of Time Sync

TCP - Time Protocol

When used via TCP the time service works as follows:

S: Listen on port 37 (45 octal).

U: Connect to port 37.

S: Send the time as a 32 bit binary number.

U: Receive the time.

U: Close the connection.

S: Close the connection.

The server listens for a connection on port 37. When the connection is established, the server returns a 32-bit time value and closes the connection. If the server is unable to determine the time at its site, it should either refuse the connection or close it without sending anything.

UDP - Time Protocol

When used via UDP the time service works as follows:

S: Listen on port 37 (45 octal).

U: Send an empty datagram to port 37.

S: Receive the empty datagram.

S: Send a datagram containing the time as a 32 bit binary number.

U: Receive the time datagram.

The server listens for a datagram on port 37. When a datagram arrives, the server returns a datagram containing the 32-bit time value. If the server is unable to determine the time at its site, it should discard the arriving datagram and make no reply.

The Time

The time is the number of seconds since 00:00 (midnight) 1 January 1900 GMT, such that the time 1 is 12:00:01 am on 1 January 1900 GMT; this base will serve until the year 2036.

For example: